The Wireless Canon Lens Control enables the focus, iris, zoom, and camera VTR functions to be controlled through a 2.4 GHZ wireless link. Hand Units of the FI+Z family give the camera assistant team complete flexibility to control the lens from a single FIZ3/Microforce hand unit (pictured on left) or to split off the three lens functions using separate controls as required (center and right).

The Focus/Iris control (center) takes over either the focus or iris function from the HU3 as determined by the setting of its selection switch. The Radio Micro Force (right) carries out the zoom function when its presence is detected by the Canon Lens Control.

Operation

1. Connect the Wireless Canon Lens Control unit to the Lens using interface cable 4546.

2. Press the Power Key. The two digit channel display will light.

3. Press the keys corresponding to the functions that are to be controlled remotely. The LED's will indicate the active selection(s).

4. Select the desired radio channel for the Canon Lens Wireless Control using the up/down keys to the right of the channel indication display. There are 30 channels (0 - 29).

5. Set the channels on the hand units to the same channel as above.

6. When only the FIZ3/Microforce is powered, it will control all three lens functions. If one or more additional hand units are detected, control will be passed from the FI+Z/Microforce to the active single function hand unit (Focus/Iris and/or Radio Micro Force).

7. To turn off the power from the FIZ3 hand unit (HU3) or the Canon Wireless Interface unit, keep the power button depressed for approximately 5s, until the LED's go off.

System Components

p/n		Description
4052		Wireless Canon Control complete with 20-pin Hirose lens cable and clamp for 15mm matte box support rods.
4060		Hand Unit 3 w/6xRings, 2xFM50 Li Batteries, Charger, Grip Quick Release
1110		Analog Microforce Zoom Control
1210		Digital Microforce Zoom Control
4336		Bracket for V+F2 and Digital Micro Force Zoom
4625		Power Cable 24V 8' (XLR3
4640		Power Cable 12V 8' (XLR4)
4641		Power Cable Anton Bauer
4642		Power Cable 12-pin Hirose (Fujinon Lens).
4540		Cable: Analog Microforce to HU3 (bracket mount)
4545		Cable: Digital Microforce to HU3 (bracket mount)

Specifications:

Power Requirement: 12VDC @ 0.10A.
Size: 4.2 x.2.6 x 1.5 inches. (107 x 66 x 38mm). Weight 10 oz (280g).
Antenna: RP-SMA.
Operating Band: 2.4 GHz Power: 20dBm (peak), 10dBm average.

> back to Products page